top of page
men working.jpg

Mincey "Quick Grab" Cast Marble Adhesive has a superior bond for commercial installation

Cast Marble Adhesive

Mincey Cast Marble Adhesive is a single component construction adhesive. When fully cured, Mincey CMA achieves over 50 psi of bond area. It’s thixotropic viscosity allows it to be applied on vertical or overhead surfaces without sagging.  Bracing can be removed several times faster than typical panel board adhesive. Mincey CMA is easier to dispense and tool at a wide range of temperatures due to its advanced formulation. Approved for adhering cast marble panels to: sheetrock, green board, blue board, cement board, concrete block (painted or unpainted), ceramic tile, cast marble panels, natural stone and wood.  Note: If applying to existing panels or tile, surfaces must be cleaned to remove old water/soap film and residues. The photograph below illustrates application of adhesives we have tried. 

Here to see more about our CMA

roger.jpg
Untitled.png
mincey install workers

Order

Here

Order

ResizeImage.aspx.jpg

Quick

Grab

Application- vertical, Substrate - sheetrock, room temp = 68.  warmer conditions did effect the other adhesives even more adversely.  Unlike the competitors.  

 

Mincey CMA held vertically and horizontally without sagging or skinning over before we could use it.

Here to see more about our CMA

bathroom.jpg

Order

Here

Order

bottom of page